Brady 3481 - Manual (Page 41)

31
4.0.6 Resetting the Printer
Depending upon the method used, there are three reset levels possible:
4.0.6.1 Soft Reset
To reset the printer and clear any temporary host settings:
With the printer ‘On’, press and hold the CANCEL key for approximately four
seconds.
4.0.6.2 Level One Reset
To return the printer to the factory default settings or, if saved, to restore the
Factory Setting File:
Œ Turn ‘Off’ the printer.
• Press and hold the PAUSE and CANCEL keys while turning ‘On’ the
printer; continue to depress the keys until the ‘SYSTEM RESET’ message
flashes.
þ Note: This reset has the same effect as the System Settings/Set
Factory Defaults selection in the menu system. (See Section 4.1
for a listing of the factory default settings and Section 4.1.5 for
information about the Factory Setting File.)
4.0.6.3 Level Two Reset
To return the printer to the factory default settings, and clear all the calibration
and adjustment parameters:
Œ Turn ‘Off’ the printer.
• Press and hold the PAUSE, FEED, and CANCEL keys while turning ‘On’
the printer; continue to depress the keys until the ‘SYSTEM RESET’
message flashes.
þ Note: After executing a Level 2 Reset, the media calibration must be
performed; see Section 5.0. A listing of the factory default
settings can be found in Section 4.1.