Sindoh M612 - Manual (Page 158)

Settings and changes of each function and additional functions
4-
16
Menu Description Value
Idle P. Sleeptime Set the time to go into Intelligent
Power Save mode from idle operation
mode. 1~60
(1*)
Factory Default
Settings Restore factory default Are you sure to reset the settings?
Cancel / OK
Check Rollermark Determin whether to remove the roller
marks when a scan job is made using
the Original Contact Glass Yes, No*
Firmware Update Firmware update from Network Network Available ?
Cancel / OK
(*) is factory default settings.
Reset to Factory Default Settings
To reset the current settings to the factory default settings, select the factory setting menu from the general
setting menu, and follow the steps described below:
Follow the instruction below to reset to the factory default settings.
1 Press [Settings] by sliding the lower side menu bar to the left in the home screen.
2 Press [General Settings]