Sindoh M612 - Manual (Page 197)

4-
55
Settings and changes of each function and additional functions
4
WEP
Enter the WEP security key for authentication. If a connection is successfully made, the wireless network
setting is completed.
Note
- WEP is an encryption method used in wireless network connections. WEP encryption key for 64 bit
or 128 bit is used.
WPA/WPA2
Enter WPA shared key. If a connection is successfully made, the wireless network setting is completed.
Note
- Just as WEP, WPA uses TKIP (Temporal Key Integrity Protocol) and AES(Advanced Encryption
Standard) for data encryption.
Enterprise WPA/ Enterprise WPA2(Wireless IEEE802.1x&EAP)
In case of enterprise WPA/enterprise WPA2, you have to enter the user ID and password for user
authentication. See Entering Wireless Security Password and follow the LCD messages to enter the user
ID and password. If a connection is successfully made, the wireless network setting is completed.
Entering Wireless Security Password
Follow the steps below to enter the password to access the wireless AP.
① When a window for entering the password appears, a virtual key board is show up.
② Enter your wanted password and then press [OK] button on the virtual key board.
③ If you need to cancel the entry, press 【←】 button. In case you do not want to enter a password, press
【ⓧ】 key.
Entering password has been completed, press 【Save】button on the password entry window.
Caution
- When entering your password, for the security reason, it appears [*].