Checking status - programming, Readback, Checking status - readback – ADS Environmental Services Enigma-hyQ QR 775017 A2 User Manual

Page 18

Advertising
background image

ADS Enigma/Enigma-Compact/Enigma-hyQ User Manual

14

Checking Status - Programming

Briefly press the green button.

LED

Indication

On

Logger programming was a success.

Flashing

Logger was detected, but failed
programming

Off

Logger was not detected

Readback

Readback data from the loggers into the case in the following way:

1. Press the red button until the system begins beeping fast.

2. Close the case. Short beeps indicate that readback is in process.

3. After hearing a long beep, indicating the readback process is complete,

open the case.

4. Check for a solid LED for each logger to verify readback success. A

flashing LED indicates a failure to readback. Logger status displays
for only 8 seconds. To re-display the status information, follow the
instructions in the following section, Checking Status - Readback.

If readback fails, repeat the readback process.

Once the readback process is successful and complete, use the PC to retrieve
the information stored in the case. Reprogram and redeploy the loggers as
required.

Checking Status - Readback

Briefly press the red button.

LED

Indication

On

Logger readback was a success.

Flashing

Logger was detected, but readback
failed.

Off

Logger was not detected.

Advertising
This manual is related to the following products: