Combi 8040 - Manual (Page 25)

Connect lower anchor connectors to vehicle lower anchors:
- Position red release button of push-on connector facing away from base
and wording on back side of connector facing base. If connector is not in
this position, turn connector over.
- Position the slot of the push-on connector over the vehicle anchorage. Push
connector in to lock onto the vehicle anchorage (fig. f). You should hear a click.
- Pull on connector to be sure it is locked onto the anchorage.
- Repeat for connector on opposite side.
Tighten lower anchorage belt to secure the base. Press down
in center of base to depress the vehicle cushion and pull free
end of lower anchor belt to tighten belt around base (fig. g).
Check for secure installation. Pull base front to back and left
to right to check for secure installation (fig. h). LATCH belt
MUST stay tight.
If LATCH belt does not stay tight or base can not be securely
installed, try a different LATCH location or use the vehicle’s
seat belt to secure
the base. 24
(fig. f)
(fig. h)
10
11
(fig. g)
8040 (EN) 122904.qxd 12/29/04 9:17 PM Page 25