Combi 8040 - Manual (Page 53)

While holding vehicle seat belts to together at latch plate (fig. a), unbuckle belt.
Slide vehicle belt out of vehicle lap belt guide on the side of the seat or base which
the buckle is on.
Slide locking clip onto vehicle seat belts approximately 1/2 inch (1 cm) away from latch
plate (fig. b).
Slide vehicle belt back into vehicle lap belt guide.
- Check to be sure vehicle lap belt is still correctly routed throughout entire belt path.
Re-buckle vehicle seat belt.
Test installation to see if car seat or base is secure.
If not secure, additional vehicle seat belt tightening may be necessary.
• Unbuckle vehicle seat belt.
• Hold vehicle seat belts together and remove locking clip.
• Shorten length of vehicle lap belt portion slightly by pulling vehicle lap belt through
latch plate.
• Re-attach locking clip.
• Buckle vehicle seat belt.
HINT: Press car seat or base down into vehicle seat cushion to help buckle vehicle seat belt.
Test installation to see if car seat or base is secure, if not secure, repeat above steps until
car seat is secure.
2
3
4
52
(fig. a)
(fig. b)
5
1/2 inch (1 cm)
6
7
8040 (EN) 122904.qxd 12/29/04 9:17 PM Page 53