Combi 8040 - Manual (Page 30)

29
Route vehicle lap belt through base.
a. Starting on side of base where lap belt is attached to vehicle, route belt up
over outside of blue belt guide , into belt slot, down the outside of the
base and across the bottom of the base to the opposite side (fig. c).
b. On opposite side of car seat, thread vehicle lap belt up between base
and blue belt guide and place lap belt into belt slot on blue belt guide
and down over outside of blue belt guide (fig. d).
c. Buckle belt.
d. Check that vehicle lap belt is not twisted and lays flat across bottom of
base.
NOTE: When installing with a lap and shoulder belt, route only the lap belt
through the base, DO NOT route the shoulder belt through base.
(fig. c)
1
2
6
1
2
3
4
(fig. d)
3
4
8040 (EN) 122904.qxd 12/29/04 9:17 PM Page 30