Combi 8040 - Manual (Page 41)

Changing Shoulder Harness Slot Position:
1. Buckle Harness and chest clip.
2. Loosen harness straps, (see “Harness Use And Adjustment” section).
3. From back of car seat unhook both harness loops from
metal harness plate (fig. b).
4. From front of car seat, pull harness straps out through infant
insert, seat pad, and car seat shell.
5. From front of car seat, rethread harness straps through infant insert,
desired harness strap slots of seat pad, and seat back.
Make sure harness straps are not twisted
and are threaded through matching slot of
infant insert, seat pad and seat back.
6. From back of car seat, route shoulder straps
between plastic seat and metal rod, then
re-attach harness adjustment loops to metal
harness plate (fig. c).
Check that loops are completely in slots of metal
harness plate and under tabs on both sides.
40
Metal
Harness Plate
(fig. c)
Tab
Shoulder
Harness
Loops
(fig. b)
Metal
Harness Plate
8040 (EN) 122904.qxd 12/29/04 9:17 PM Page 41