Dell PowerVault 124T - Manual (Page 11)

Installing the Autoloader: Dell PowerVault 124T DLT VS160 Autoloader User's Guide
file:///T|/htdocs/stor-sys/124T/en/124tvs16/install.html[12/5/2012 10:25:55 AM]
4. Right-click the Unknown Medium Changer Device listing and click Properties.
5. Select the Driver tab.
6. When the Upgrade Device Driver Wizard appears, click Next.
7. Click Display a list... and then click Next.
8. Click Have Disk, type d:\Drivers\Autoloader, replacing d: with the drive letter for the CD drive into which you
inserted the Dell PowerVault 124T Autoloader User's Manual and Drivers CD, and then click OK.
9. Click the Dell (tm) PowerVault (tm) 124T Autoloader entry and click Next.
10. Click Next again to install the driver.
11. Click Finish.
12. Close the Device Properties dialog box.
The autoloader now appears in Device Manager under Medium Changers as a Dell (tm) PowerVault (tm) 124T
Autoloader, and is ready to use.
Microsoft Windows Server 2003:
1. Make sure that you are logged on to the host server with administrator privileges.
2. Insert the Dell PowerVault 124T Autoloader User's Manual and Drivers CD into the CD drive on the host server.
3. Right-click the My Computer icon on the Windows desktop, click Manage, and then click Device Manager.
The autoloader should be listed under Medium Changers as Unknown Medium Changer Device.
4. Right-click the Unknown Medium Changer Device listing and click Properties.
5. Select the Driver tab.
6. When the Upgrade Device Driver Wizard appears, click Next.
7. Click Display a list... and then click Next.
8. Click Have Disk, type d:\Drivers\Autoloader, replacing d: with the drive letter for the CD drive into which you
inserted the Dell PowerVault 124T Autoloader User's Manual and Drivers CD, and then click OK.
9. Click the Dell (tm) PowerVault (tm) 124T Autoloader entry and click Next.
10. Click Next again to install the driver.
11. Click Finish.
12. Close the Device Properties dialog box.
The autoloader now appears in Device Manager under Medium Changers as a Dell (tm) PowerVault (tm) 124T
Autoloader, and is ready to use.
Enabling LUN Support in Linux
To verify the detection of a tape drive, administrators should check for its entry in /proc/scsi/scsi. Current versions of Linux
may not scan the logical storage unit (LUN) ID of every device. This can result in some PowerVault devices not being
identified or listed in the /proc/scsi/scsi output. Administrators can follow these steps to enable support for such devices.
1. Type cat/proc/scsi/scsi. The output will look similar to the following:
Attached devices:
Host: scsi3 Channel: 00 Id: 00 Lun: 00
Vendor: Quantum Model: DLT VS160 Rev: 3100
Type: Sequential -Access ANSI SCSI revision: 03