Dell PowerVault 124T - Manual (Page 33)

Remote Management Unit: Dell PowerVault 124T DLT VS160 Autoloader User's Guide
file:///T|/htdocs/stor-sys/124T/en/124tvs16/rmu.html[12/5/2012 10:26:00 AM]
From a remote location, you can request that a tape be moved from one position to another. To move a tape:
1. From any page, click the Library Operations heading. The Library Operations screen displays.
2. From the Moving Tapes section of the page, click the drop-down menu under From: and select the current location of
the tape that you want to move.
NOTE: You can also click the slot on the graphic of the autoloader magazine to select and move a cartridge.
3. From the drop-down menu under To:, select the location to which you want to move the tape, and then click submit.
Inventory
The autoloader automatically runs an inventory whenever you power it on or insert a magazine. If you need to run an
inventory in addition to this, you can use the Remote Management Unit to do it remotely. To run an inventory:
1. From any page, click the Library Operations heading. The Library Operations screen displays.
2. From the Library Operations page, click Inventory. The autoloader starts an inventory immediately.
Set to Home
If the autoloader is not able to successfully execute a Moving Tapes or an Inventory command, try executing a Set to
Home command, and then retry the move or inventory command again.
The Set to Home command resets the autoloader as a means to help the autoloader recover from an unexpected internal
condition. To Set to Home:
1. From any page, click the Library Operations heading. The Library Operations screen displays.
2. From the Library Operations page, click Set to Home. This executes a reset command to the autoloader.
Back to Contents Page