Dell PowerVault 124T - Manual (Page 55)

Troubleshooting: Dell PowerVault 124T DLT VS160 Autoloader User's Guide
file:///T|/htdocs/stor-sys/124T/en/124tvs16/trouble.htm[12/5/2012 10:26:08 AM]
7D SCSI Error During Write
Buffer Command
7E Uncompressed EDC Failure
7F Image Processing Ended
Early
SCSI Server Task Error Types
80 Unexpected Response or
Data Received Verify the host backup application and device driver are at the latest
supported revision at support.dell.com .
Check host adapter and SCSI cables and terminator.
Power cycle the autoloader and retry the operation.
If all previous steps fail, contact support.dell.com .
81 Drive Send Failed
Servo Elevator Hardware Error Types
92 Elevator Flag Bad
Power cycle the autoloader
Run the Random Moves test from either the Remote Management Unit
(RMU) or the Operator Control Panel (OCP).
Note: The Random Moves test requires a minimum of two cartridges
present within the autoloader.
Check support.dell.com for PowerVault 124T firmware updates.
If all previous steps fail, contact support.dell.com .
93 Elevator Sensor Bad
97 Elevator Calibration Lost
98 Elevator Calibration
Jammed
99 Elevator Lost
9B Elevator Position Error
Picker/Magazine Servo Error Types
A0 Servo Error
Power cycle the autoloader.
Run the Random Moves test from either the Remote Management Unit
(RMU) or the Operator Control Panel (OCP).
Also execute the Recommended Actions for "Open Front" (4B) error type.
Note: The Random Moves test requires a minimum of two cartridges
present within the autoloader.
Check support.dell.com for PowerVault 124T firmware updates.
If all previous steps fail, contact support.dell.com .
A1 Reserved Error Code
A2 Servo Timeout Error
A3 Position Error
A4 Servo Not Calibrated
A5 Source Element Empty
Verify that the expected source really does not have a cartridge.
Power cycle the autoloader.
Run the Random Moves test from either the Remote Management Unit
(RMU) or the Operator Control Panel (OCP).
Note: The Random Moves test requires a minimum of two cartridges
present within the autoloader.
If the source is a slot within a magazine, check if the spring loaded
cartridge present flag moves freely when the cartridge is manually inserted
into the magazine.
If the error continues, contact support.dell.com .