Dell PowerEdge R810 - Manual (Page 145)

Installing System Components 145
Figure 3-27. Replacing the System Battery
3 Locate the battery socket. See Figure 6-1.
4 If installed, remove the storage controller card. See "Removing the
Integrated Storage Controller Card" on page 126.
CAUTION: To avoid damage to the battery connector, you must firmly support the
connector while installing or removing a battery.
5 To remove the battery, support the battery connector by pressing down
firmly on the positive side of the connector.
6 Lift the battery out of the securing tabs at the negative side of the
connector.
7 To install a new system battery, support the battery connector by pressing
down firmly on the positive side of the connector.
8 Hold the battery with the "+" facing up and slide it under the securing
tabs at the positive side of the connector.
1 positive side of battery connector 2 system battery
3 negative side of battery connector
3
1
2
book.book Page 145 Thursday, February 18, 2010 2:06 PM