Dell PowerEdge R810 - Manual (Page 159)

Installing System Components 159
16 If applicable, install the NIC hardware key on the system board. See
"Internal NIC Hardware Key" on page 113.
17 Install the expansion card risers. See "Installing Expansion-Card Riser 1"
on page 121 and "Installing Expansion-Card Riser 2" on page 122.
18 Install all expansion cards and the integrated storage controller card. See
"Installing an Expansion Card" on page 116 and "Installing the Integrated
Storage Controller Card" on page 128.
19 Slide the front-chassis assembly back into the system. See "Front-Chassis
Assembly" on page 98.
20 Connect the cables to the system board assembly, SAS backplane, control
panel board, and the optical drive.
21 Route the power/data cables along the chassis wall. See step 2 and step 3 of
"Sliding the Front-Chassis Assembly" on page 98.
22 Replace the cooling shroud. See "Installing the Cooling Shroud" on
page 97.
23 Close the system. See "Closing the System" on page 85.
24 If applicable, install the front bezel. See "Installing the Front Bezel" on
page 83.
25 Reconnect the system to its electrical outlet and turn the system on,
including any attached peripherals.
book.book Page 159 Thursday, February 18, 2010 2:06 PM