Dell POWEREDGE M1000E - Manual (Page 1010)

B-94
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Command Reference
OL-13271-03
Appendix B Cisco Catalyst Blade Switch 3130 and 3032 for Dell Debug Commands
debug vqpc
debug vqpc
Use the debug vqpc privileged EXEC command to enable debugging of the VLAN Query Protocol
(VQP) client. Use the no form of this command to disable debugging.
debug vqpc [all | cli | events | learn | packet]
no debug vqpc [all | cli | events | learn | packet]
Syntax Description
Defaults Debugging is disabled.
Command Modes Privileged EXEC
Command History
Usage Guidelines The undebug vqpc command is the same as the no debug vqpc command.
On a stacking-capable switch, when you enable debugging, it is enabled only on the stack master. To
enable debugging on a stack member, you can start a session from the stack master by using the session
switch-number privileged EXEC command. Then enter the debug command at the command-line
prompt of the stack member. You also can use the remote command stack-member-number LINE
privileged EXEC command on the stack master switch to enable debugging on a member switch without
first starting a session.
Related Commands
all (Optional) Display all VQP client debug messages.
cli (Optional) Display the VQP client command-line interface (CLI) debug
messages.
events (Optional) Display VQP client event debug messages.
learn (Optional) Display VQP client address learning debug messages.
packet (Optional) Display VQP client packet information debug messages.
Release Modification
12.2(40)EX1 This command was introduced.
Command Description
show debugging Displays information about the types of debugging that are enabled.