Dell POWEREDGE M1000E - Manual (Page 932)

B-16
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Command Reference
OL-13271-03
Appendix B Cisco Catalyst Blade Switch 3130 and 3032 for Dell Debug Commands
debug ip igmp snooping
debug ip igmp snooping
Use the debug igmp snooping privileged EXEC command to enable debugging of Internet Group
Management Protocol (IGMP) snooping activity. Use the no form of this command to disable
debugging.
debug ip igmp snooping [group | management | querier | router | timer]
no debug ip igmp snooping [group | management | querier | router | timer]
Syntax Description
Defaults Debugging is disabled.
Command Modes Privileged EXEC
Command History
Usage Guidelines The undebug ip igmp snooping command is the same as the no debug ip igmp snooping command.
On a stacking-capable switch, when you enable debugging, it is enabled only on the stack master. To
enable debugging on a stack member, you can start a session from the stack master by using the session
switch-number privileged EXEC command. Then enter the debug command at the command-line
prompt of the stack member. You also can use the remote command stack-member-number LINE
privileged EXEC command on the stack master switch to enable debugging on a member switch without
first starting a session.
Related Commands
group (Optional) Display IGMP snooping group activity debug messages.
management (Optional) Display IGMP snooping management activity debug messages.
querier (Optional) Display IGMP snooping querier debug messages.
router (Optional) Display IGMP snooping router activity debug messages.
timer (Optional) Display IGMP snooping timer event debug messages.
Release Modification
12.2(40)EX1 This command was introduced.
Command Description
debug platform ip
igmp snooping Displays information about platform-dependent IGMP snooping activity.
show debugging Displays information about the types of debugging that are enabled.