Dell POWEREDGE M1000E - Manual (Page 946)

B-30
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Command Reference
OL-13271-03
Appendix B Cisco Catalyst Blade Switch 3130 and 3032 for Dell Debug Commands
debug platform cisp
debug platform cisp
Use the debug platform cisp global configuration command to enable platform-level debugging of a
switch that has one or more Client Information Signalling Protocol (CISP)-enabled interfaces. Use the
no form of this command to disable debugging.
debug platform cisp [initialization | interface-configuration | rpc]
no debug platform cisp [initialization | interface-configuration | rpc]
Syntax Description
Defaults Debugging is disabled.
Command Modes Privileged EXEC
Command History
Usage Guidelines When you enable debugging, it is enabled only on the stack master. To enable debugging on a stack
member, start a session from the stack master by using the session switch-number privileged EXEC
command and enter enter the debug command at the command-line prompt of the stack member. You
also can use the remote command stack-member-number <line> privileged EXEC command on the
stack master switch to enable debugging on a member switch without first starting a session.
Related Commands
initialization Enable debugging of the CISP initialization sequence.
interface-configuration Enable debugging of the CISP configuration.
rpc Enable debugging of the CISP RPC requests.
Release Modification
12.2(50)SE This command was introduced.
Command Description
cisp enable Enables Client Information Signalling Protocol
(CISP)
dot1x credentials (global configuration) profile Configures a profile on a supplicant switch.
show cisp Displays CISP information for a specified
interface.