Vlan database – Dell POWEREDGE M1000E User Manual
Page 867
2-837
Cisco Catalyst Blade Switch 3120 for HP Command Reference
OL-12248-03
Chapter 2 Cisco Catalyst Blade Switch 3120 for HP Cisco IOS Commands
vlan database
vlan database
Use the vlan database privileged EXEC command on the switch stack or on a standalone switch to enter
VLAN configuration mode. From this mode, you can add, delete, and modify VLAN configurations for
normal-range VLANs and globally propagate these changes by using the VLAN Trunking Protocol
(VTP). Configuration information is saved in the VLAN database.
vlan database
Note
VLAN configuration mode is only valid for VLAN IDs 1 to 1005.
Syntax Description
This command has no arguments or keywords.
Defaults
No default is defined.
Command Modes
Privileged EXEC
Command History
Usage Guidelines
You can use the VLAN database configuration commands to configure VLANs 1 to 1005. To configure
extended-range VLANs (VLAN IDs 1006 to 4094), use the
command to
enter config-vlan mode. You can also configure VLAN IDs 1 to 1005 by using the vlan global
configuration command.
To return to the privileged EXEC mode from the VLAN configuration mode, enter the exit command.
Note
This command mode is different from other modes because it is session-oriented. When you add, delete,
or modify VLAN parameters, the changes are not applied until you exit the session by entering the apply
or exit command. When the changes are applied, the VTP configuration version is incremented. You can
also not apply the changes to the VTP database by entering abort.
When you are in VLAN configuration mode, you can access the VLAN database and make changes by
using these commands:
•
vlan: accesses subcommands to add, delete, or modify values associated with a single VLAN. For
more information, see the
command.
•
vtp: accesses subcommands to perform VTP administrative functions. For more information, see the
command.
Release
Modification
12.2(40)EX1
This command was introduced.