Dell POWEREDGE M1000E - Manual (Page 1051)

C-41
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Command Reference
OL-13271-03
Appendix C Cisco Catalyst Blade Switch 3130 and 3032 for Dell Show Platform Commands
show platform stack ports
show platform stack ports
Use the show platform stack ports privileged EXEC command to display platform-dependent stack
information.
show platform stack ports {buffer | history}[ | {begin | exclude | include} expression]
Note This command is supported only on stacking-capable switches.
Syntax Description
Command Modes Privileged EXEC
Command History
Usage Guidelines Use this command only when you are working directly with your technical support representative while
troubleshooting a problem. Do not use this command unless your technical support representative asks
you to do so.
Expressions are case sensitive. For example, if you enter | exclude output, the lines that contain output
do not appear, but the lines that contain Output appear.
Examples This is an example of the show platform stack port buffer command output:
Switch# show platform stack ports buffer
Stack Debug Event Data Trace
==============================================================
Event type LINK: Link status change
Event type RAC: RAC changes to Not OK
Event type SYNC: Sync changes to Not OK
==============================================================
Event Stack Stack PCS Info Ctrl-Status Loopback Cable
Count Port IOS / HW length
========= ===== =================================== =========== ======== ========
Event type: LINK OK Stack Port 1
0000000011 1 FF08FF00 860302A5 AA55FFFF FFFFFFFF 1CE61CE6 Yes/Yes No cable
0000000011 2 FF08FF00 86031805 55AAFFFF FFFFFFFF 1CE61CE6 Yes/Yes No cable
Event type: LINK OK Stack Port 2
buffer Display the stack port link and sync state events.
history Display the stack port history.
| begin (Optional) Display begins with the line that matches the expression.
| exclude (Optional) Display excludes lines that match the expression.
| include (Optional) Display includes lines that match the specified expression.
expression Expression in the output to use as a reference point.
Release Modification
12.2(50)SE This command was introduced.