Dell POWEREDGE M1000E - Manual (Page 364)

2-334
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Command Reference
OL-13271-03
Chapter 2 Cisco Catalyst Blade Switch 3130 and 3032 for Dell Cisco IOS Commands
mls qos map
mls qos map
Use the mls qos map global configuration command on the switch stack or on a standalone switch to
define the class of service (CoS)-to-Differentiated Services Code Point (DSCP) map, DSCP-to-CoS
map, the DSCP-to-DSCP-mutation map, the IP-precedence-to-DSCP map, and the policed-DSCP map.
Use the no form of this command to return to the default map.
mls qos map {cos-dscp dscp1...dscp8 | dscp-cos dscp-list to cos | dscp-mutation
dscp-mutation-name in-dscp to out-dscp | ip-prec-dscp dscp1...dscp8 | policed-dscp dscp-list
to mark-down-dscp}
no mls qos map {cos-dscp | dscp-cos | dscp-mutation dscp-mutation-name | ip-prec-dscp |
policed-dscp}
Syntax Description cos-dscp dscp1...dscp8 Define the CoS-to-DSCP map.
For dscp1...dscp8, enter eight DSCP values that correspond to CoS values 0
to 7. Separate each DSCP value with a space. The range is 0 to 63.
dscp-cos dscp-list to
cos Define the DSCP-to-CoS map.
For dscp-list, enter up to eight DSCP values, with each value separated by a
space. The range is 0 to 63. Then enter the to keyword.
For cos, enter a single CoS value to which the DSCP values correspond. The
range is 0 to 7.
dscp-mutation
dscp-mutation-name
in-dscp to out-dscp Define the DSCP-to-DSCP-mutation map.
For dscp-mutation-name, enter the mutation map name.
For in-dscp, enter up to eight DSCP values, with each value separated by a
space. Then enter the to keyword.
For out-dscp, enter a single DSCP value.
The range is 0 to 63.
ip-prec-dscp
dscp1...dscp8 Define the IP-precedence-to-DSCP map.
For dscp1...dscp8, enter eight DSCP values that correspond to the IP
precedence values 0 to 7. Separate each DSCP value with a space. The range
is 0 to 63.
policed-dscp dscp-list
to mark-down-dscp Define the policed-DSCP map.
For dscp-list, enter up to eight DSCP values, with each value separated by a
space. Then enter the to keyword.
For mark-down-dscp, enter the corresponding policed (marked down) DSCP
value.
The range is 0 to 63.