Dell POWEREDGE M1000E - Manual (Page 192)

2-162
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Command Reference
OL-13271-03
Chapter 2 Cisco Catalyst Blade Switch 3130 and 3032 for Dell Cisco IOS Commands
errdisable detect cause
errdisable detect cause
Use the errdisable detect cause global configuration command on the switch stack or on a standalone
switch to enable error-disabled detection for a specific cause or all causes. Use the no form of this
command to disable the error-disabled detection feature.
errdisable detect cause {all | arp-inspection | bpduguard | dhcp-rate-limit | dtp-flap |
gbic-invalid | l2ptguard | link-flap | loopback | pagp-flap | sfp-config-mismatch}
no errdisable detect cause {all | arp-inspection | bpduguard | dhcp-rate-limit | dtp-flap |
gbic-invalid | l2ptguard | link-flap | loopback | pagp-flap | sfp-config-mismatch}
For the BPDU guard and port-security features, you can use this command to globally configure the
switch to shut down just the offending VLAN on the port when a violation occurs, instead of shutting
down the entire port.
When the per-VLAN error-disable feature is turned off and a BPDU guard violation occurs, the entire
port is disabled. Use the no form of this command to disable the per-VLAN error-disable feature.
errdisable detect cause bpduguard shutdown vlan
no errdisable detect cause bpduguard shutdown vlan
Syntax Description
Note Though visible in the command-line help strings, the inline-power keyword is not supported.
Defaults Detection is enabled for all causes.
all Enable error detection for all error-disabled causes.
arp-inspection Enable error detection for dynamic Address Resolution Protocol
(ARP) inspection.
bpduguard shutdown vlan Enable per-VLAN error-disable for BPDU guard.
dhcp-rate-limit Enable error detection for DHCP snooping.
dtp-flap Enable error detection for the Dynamic Trunking Protocol (DTP)
flapping.
gbic-invalid Enable error detection for an invalid Gigabit Interface Converter
(GBIC) module.
Note This error refers to an invalid small form-factor pluggable
(SFP) module.
l2ptguard Enable error detection for a Layer 2 protocol-tunnel error-disabled
cause.
link-flap Enable error detection for link-state flapping.
loopback Enable error detection for detected loopbacks.
pagp-flap Enable error detection for the Port Aggregation Protocol (PAgP) flap
error-disabled cause.
sfp-config-mismatch Enable error detection on an SFP configuration mismatch.