Installing the chassis intrusion switch – Dell PowerEdge T710 User Manual
Page 131
Advertising
Installing System Components
131
Installing the Chassis Intrusion Switch
1 Align the chassis intrusion switch with the securing bracket notch. See
Figure 3-22.
2 Slide the switch into the securing bracket notch. See Figure 3-22.
3 Connect the chassis intrusion switch cable to the connector on the system
board.
4 Close the system. See "Closing the System" on page 86.
5 Place the system upright and on its feet on a flat, stable surface.
6 Rotate the system feet outward.
7 Reattach any peripherals and connect the system to an electrical outlet.
8 Turn on the system and attached peripherals.
book.book Page 131 Monday, June 15, 2009 11:33 AM
Advertising