System battery, Replacing the system battery – Dell PowerEdge T710 User Manual
Page 144
144
Installing System Components
System Battery
Replacing the System Battery
WARNING:
Only trained service technicians are authorized to remove the system
cover and access any of the components inside the system. Before you begin this
procedure, review the safety instructions that came with the system.
WARNING:
There is a danger of a new battery exploding if it is incorrectly
installed. Replace the battery only with the same or equivalent type recommended
by the manufacturer. See your safety information for additional information.
1 Turn off the system, including any attached peripherals, and disconnect
the system from the electrical outlet.
2 Rotate the system feet inward and lay the system on a flat surface.
3 Open the system. See "Opening the System" on page 85.
4 Remove the cooling shroud. See "Removing the Cooling Shroud" on
5 Remove the fan modules. See "Removing a Cooling-Fan Module" on
6 Remove the fan cage. See "Removing the Fan Cage" on page 138.
Figure 3-27.
Replacing the System Battery
7 Locate the battery socket. See "System Board Connectors" on page 186.
CAUTION:
To avoid damage to the battery connector, you must firmly support the
connector while installing or removing a battery.
book.book Page 144 Monday, June 15, 2009 11:33 AM