Installing the cooling shroud – Dell PowerEdge T710 User Manual
Page 88
88
Installing System Components
Figure 3-5.
Removing and Installing the Cooling Shroud
Installing the Cooling Shroud
1 Align the cooling shroud with the alignment guides in the system.
2 Carefully lower the cooling shroud into the system until the securing tab
snaps over the shroud using the tab projection on the shroud as a
guidance. Ensure that no cables are pinned under the edges of the cooling
shroud.
3 Close the system. See "Closing the System" on page 86.
4 Place the system upright and on its feet on a flat, stable surface.
5 Rotate the system feet outward.
6 Reattach any peripherals, then connect the system to the electrical outlet.
7 Turn on the system and attached peripherals.
1
cooling shroud
2
cooling shroud release tab
1
2
book.book Page 88 Monday, June 15, 2009 11:33 AM