Dell PowerEdge T710 User Manual
Page 135
Installing System Components
135
Removing an Integrated Storage Controller Card Carrier
WARNING:
Only trained service technicians are authorized to remove the system
cover and access any of the components inside the system. Before you begin this
procedure, review the safety instructions that came with the system.
1 Turn off the system, including any attached peripherals, and disconnect
the system from the electrical outlet and peripherals.
2 Rotate the system feet inward and lay the system on a flat surface.
3 Open the system. See "Opening the System" on page 85.
4 Remove the storage controller card. See "Removing an Integrated Storage
5 Disconnect the chassis intrusion switch cable from the system board.
6 Press the blue tab towards the inside of the system and slide the carrier up
and out of the securing tabs.
Installing an Integrated Storage Controller Card Carrier
1 Position the storage controller card carrier by aligning the slots on the
carrier with the tabs on the chassis.
2 Slide it down until the carrier snaps into place.
3 Connect the chassis intrusion switch cable to the system board.
4 Position the storage controller card carrier such that the slots in the carrier
are aligned to the securing tabs on the chassis.
5 Slide it down until the carrier is seated on the securing tabs.
6 Replace the integrated storage controller card. See "Installing an
Integrated Storage Controller Card" on page 134.
7 Close the system. See "Closing the System" on page 86.
8 Place the system upright and on its feet on a flat, stable surface.
9 Rotate the system feet outward.
10 Reattach any peripherals, then connect the system to the electrical outlet.
11 Turn on the system and attached peripherals.
12 Install any device drivers required for the card as described in the
documentation for the card.
book.book Page 135 Monday, June 15, 2009 11:33 AM