Dell PowerEdge T710 - Manual (Page 140)

140
Installing System Components
VFlash Media (Optional)
The VFlash media is a Secure Digital (SD) card that can be used with the
optional iDRAC6 Enterprise card.
Installing a VFlash Media
1 Locate the VFlash media slot at the back of the system. See "Back-Panel
Features and Indicators" on page 20 for the location of the media slot.
2 With the label side facing up, insert the contact-pin end of the SD card
into the card slot on the module.
NOTE:
The slot is keyed to ensure correct insertion of the card.
3 Press the card to lock it into the slot.
Removing a VFlash Media
To remove the VFlash media, push inward on the card to release it and pull
the card from the card slot.
Integrated Dell Remote Access Controller 6
(iDRAC6) Enterprise Card (Optional)
The optional iDRAC6 Enterprise card provides a set of advanced features for
managing the system remotely.
Installing an iDRAC6 Enterprise Card
WARNING:
Only trained service technicians are authorized to remove the system
cover and access any of the components inside the system. Before you begin this
procedure, review the safety instructions that came with the system.
1 Turn off the system, including any attached peripherals, and disconnect
the system from its electrical outlet.
2 Rotate the system feet inward and lay the system on a flat surface.
3 Open the system. See "Opening the System" on page 85.
4 Remove the cooling shroud. See "Removing the Cooling Shroud" on
page 87.
book.book Page 140 Monday, June 15, 2009 11:33 AM