Installing the sas backplane – Dell PowerEdge T710 User Manual
Page 151
Installing System Components
151
Installing the SAS Backplane
WARNING:
Only trained service technicians are authorized to remove the system
cover and access any of the components inside the system. Before you begin this
procedure, review the safety instructions that came with the system.
1 Align the slots on the SAS backplane with the tabs on the chassis.
2 Slide the SAS backplane until the release pin snaps into place. See
Figure 3-29.
3 Reconnect the cables that were routed over the notch in the SAS
backplane.
4 Reconnect the cables connected to the SAS backplane (see Figure 3-29):
•
SAS A cable
•
SAS B cable
(
available only with 3.5-inch SAS backplane)
•
hard drive activity indicator cable
•
backplane power cable
5 Replace all the hard drives. See "Installing a Hot-Swap Hard Drive" on
6 Replace the cooling shroud. See "Installing the Cooling Shroud" on
7 Close the system. See "Closing the System" on page 86.
8 Place the system upright and on its feet on a flat, stable surface.
9 Rotate the system feet outward
10 Install the Front Bezel. See "Installing the Front Bezel" on page 85.
11 Reattach any peripherals and connect the system to an electrical outlet.
12 Turn on the system and attached peripherals.
book.book Page 151 Monday, June 15, 2009 11:33 AM