Dell PowerEdge T710 - Manual (Page 65)

Using the System Setup Program and UEFI Boot Manager
65
PCI IRQ Assignment Screen
Serial Communication Screen
Embedded Video
Controller (Enabled
default) Enables or disables BIOS support for the integrated video
controller.
NOTE:
This field can be disabled only if an add-in video
card is present. If this field is disabled, remote access
features such as virtual KVM are not available.
Option Description
<PCIe device> Use the <+> and <-> keys to manually select an IRQ
for a given device, or select Default to allow the BIOS to
select an IRQ value at system startup.
Option Description
Serial Communication
(On without Console
Redirection default) Options are On without Console Redirection, On with
Console Redirection via COM1, On with Console
Redirection via COM2, and Off.
Serial Port Address Specifies the address of the serial ports.
External Serial Connector
(Remote Access Device
default) Specifies whether Serial Device1, Serial Device2, or
Remote Access Device has access to the external serial
connector.
Failsafe Baud Rate
(115200 default) Displays the failsafe baud rate used for console
redirection. This rate should not be adjusted.
Remote Terminal Type
(VT100/VT220 default) Options are VT100/VT220 or ANSI.
Redirection After Boot
(Enabled default) Enables or disables BIOS console redirection after the
operating system boots.
Option Description
book.book Page 65 Monday, June 15, 2009 11:33 AM