Dell PowerEdge T710 - Manual (Page 158)

158
Installing System Components
Installing the Power Distribution Board
1 Align the securing slots on the power distribution board with the tabs on
the chassis.
2 Replace the five screws securing the power distribution board to the plate.
3 Connect all the power cables to the power distribution board.
4 Lower the power distribution board plate into the chassis slightly towards
the front of the system and then slide it towards the back until it comes to
rest in position.
5 Replace the two screws on the power distribution board plate.
6 Replace the system board. See "Installing the System Board" on page 154.
7 Replace the power supplies. See "Installing a Power Supply" on page 83.
8 Close the system. See "Closing the System" on page 86.
9 Place the system upright and on its feet on a flat, stable surface.
10 Rotate the system feet outward.
11 Reattach any peripherals and connect the system to an electrical outlet.
12 Turn on the system and attached peripherals.
book.book Page 158 Monday, June 15, 2009 11:33 AM