Dell PowerEdge T710 - Manual (Page 138)

138
Installing System Components
2 Slide the module down into the slot in the fan cage until the release tabs
lock into place. See Figure 3-24.
3 Close the system. See "Closing the System" on page 86.
4 Place the system upright and on its feet on a flat, stable surface.
5 Rotate the system feet outward.
6 Reattach any peripherals, then connect the system to the electrical outlet.
7 Turn on the system and attached peripherals.
Fan Cage
Removing the Fan Cage
WARNING:
Only trained service technicians are authorized to remove the system
cover and access any of the components inside the system. Before you begin this
procedure, review the safety instructions that came with the system.
WARNING:
The cooling fans can continue to spin for some time after the system
has been powered down. Allow time for the fans to stop spinning before handling
them.
CAUTION:
The system requires at minimum a cooling-fan module to be installed
in the outer fan-module slot of the fan cage (see Figure 3-24) at all times to ensure
proper system cooling.
1 Turn off the system and attached peripherals, and disconnect the system
from the electrical outlet and peripherals.
2 Rotate the system feet inward and lay the system on a flat surface.
3 Open the system. See "Opening the System" on page 85.
4 Remove the cooling shroud. See "Removing the Cooling Shroud" on
page 87.
5 Remove the fan modules. See "Removing a Cooling-Fan Module" on
page 136.
6 Press the fan cage release tab in the direction of the arrow to unlatch it.
7 Slide up the fan cage out of the slot on the chassis.
book.book Page 138 Monday, June 15, 2009 11:33 AM