To replace mower drive belt, To replace motion drive belt, Important – Craftsman 917.28927 User Manual

Page 25

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

TO REPLACE MOWER DRIVE BELT

M O W ER DRIVE BELT REM OVAL

1. Park

tractor

on a level surface. Engage

parking brake.

2. Low er attachm ent lift lever to its lowest

position.

3.

Rem ove any dirt or grass clippings

w hich m ay have accum ulated around

m andrels and entire upper deck sur­

face.

4.

Rem ove belt from electric clutch pulley

(M),

both m andrel pulleys (R) and all

idler pulleys (S).

M O W ER DRIVE BELT INSTALLATION

1. Install belt around all m andrel pulleys

(R) and around idler pulleys (S) as

show n.

2. Install belt onto electric clutch pulley

(M).

IMPORTANT:

Check belt for proper rout­

ing in all m ow er pulley grooves.

3.

Raise attachm ent lift lever to highest

position.

TO REPLACE MOTION DRIVE BELT

Park the tractor on level surface. Engage

parking brake. For assistance, there is a

belt installation guide decal on bottom side

of left footrest.

BELT REM O VAL -

1. Rem ove m ow er (See “TO REM O VE

M O W ER” in this section of m anual).

NOTE:

O bserve entire m otion drive belt

and position of all belt guides and keep­

ers.

2.

Rem ove belt from stationary idler (A)

and clutching idler (B).

3.

Rem ove belt from centerspan idler (C).

4. Pull belt slack tow ard rear of tractor.

Carefully rem ove belt upw ards from

transm ission input pulley and over

cooling fan blades (D).

5. Rem ove belt downward from engine

pulley (E).

6. Slide belt tow ard rear of tractor, off the

steering plate (F) and rem ove from

tractor.

BELT INSTALLATIO N -

1. Install new belt from tractor rear to

front, over the steering plate (F) and

above clutch brake pedal shaft (G ).

2. Pull belt tow ard front of tractor and roll

belt onto engine pulley (E).

3. Pull belt tow ard rear of tractor. Care­

fully w ork belt dow n around transm is­

sion cooling fan and onto the input

pulley (D). Be sure belt is inside the

belt keeper.

4. Install belt on centerspan idler (C).

5. Install belt through stationary idler (A)

and clutching idler (B).

6. M ake sure belt is in all pulley grooves

and inside all belt guides and keepers.

7. Install m ow er (See “TO INSTALL

M O W ER” in this section of m anual).

25

Advertising