Catler ES 8010 - Manual (Page 15)

STEP 4 – PRIMING THE BREW HEAD
•
Before placing the Filter Holder into
position, it is recommended to run a short
fl ow of water through the Brew Head.
• Ensure the Selector Control is in the
‘Standby’ position and plug the power
cord into a 230/240V power outlet and
switch on. Press the Power On/Off button
and the button surround will illuminate.
When the machine has reached the correct
temperature the Steam button surround
will also illuminate.
• The machine will make a pumping noise
then the Heating Light will fl ash red. When
the correct temperature has been reached
the light will go out. The heating light will
cycle on and off while the machine is on in
order to maintain the correct temperature.
• Place a container or empty cup under the
Brew Head.
• With the fi lter holder removed, prime the
Brew Head by turning the Selector Control
to the ‘Espresso’ position momentarily.
A pumping noise will be heard in this
operation.
STEP 5 - PRE-WARMING THE CUPS
•
The Cup Warming Plate will start to warm
as the machine heats.
• Pre-warm the espresso cups by placing
on the Cup Warming Plate. This will help
maintain the coff ee’s optimal temperature
when brewed into the cups.
STEP 6 – INSERTING THE FILTER HOLDER
•
Place the Filter Holder underneath the
Brew Head so that the handle is aligned
with the insert graphic. Insert the Filter
Holder up into the Brew Head and rotate
the handle to the right until resistance is
felt, this will be at an approximate 90° angle
to the machine.
15 15
OPERATING YOUR ESPRESSO MACHINE ES 8010