Catler ES 8010 - Manual (Page 26)

CLEANING THE FILTERS, FILTER HOLDER AND
BREWING HEAD
•
The stainless steel Filters and Filter Holder
should be rinsed under water directly after
use to remove all coff ee particles. Should
the fi ne holes in the fi lters become blocked,
the fi ne pin on the Cleaning Tool can be
used to clear the holes.
• The Brew Head interior should be wiped
with a damp cloth to remove any ground
coff ee particles.
• Periodically run water through the machine
with the Filter Holder in place, but without
any ground coff ee, to rinse out any residual
coff ee particles.
CLEANING THE OUTER HOUSING / CUP
WARMING PLATE
•
The outer housing and cup warming plate
can be cleaned with a soft, damp cloth (do
not use abrasive cleansers, pads or cloths
which can scratch the surface).
CLEANING THE DRIP TRAY
•
The Drip Tray should be removed,
emptied and cleaned at regular intervals,
particularly when the Drip Tray Full
Indicator is showing full.
• Remove the Drip Tray Full Indicator and
Grid from the Drip Tray, wash with warm
soapy water, using a non-abrasive washing
liquid, rinse and dry thoroughly.
• If further cleaning is required the full
indicator can be removed from the drip
tray by releasing the side snaps.
CLEANING THE STORAGE TRAY
•
The Storage Tray can be removed after the
Drip Tray is removed then cleaned with
a soft, damp cloth (do not use abrasive
cleansers, pads or cloths which can scratch
the surface).
NOTE:
Do not clean any of the parts or
accessories in the dishwasher.
26
CARE AND CLEANING