Catler ES 8010 User Manual
Page 16
STEP 7 - BREWING THE COFFEE
•
The red ‘Heating’ light cycles off when
the machine has reached the correct
temperature for brewing.
•
Ensure the Drip Tray and Grid are in place.
•
Place one or two pre-warmed cups
beneath the Filter Holder outlet.
•
Set the Selector Control to the ‘Espresso’
position.
•
After a few seconds, aromatic coff ee will
begin to brew into the cups. A pumping
noise will be heard in this operation.
•
When
suffi
cient coff ee has fl owed into
the cups, set the Selector Control to the
‘Standby’ position. This will stop the fl ow of
coff ee.
•
If the steam function is not required,
leave the Selector Control to the ‘Standby’
position, unplug the power cord and allow
the machine to cool.
PRE-BREW FUNCTION
•
When the Selector Control is set to the
‘Espresso’
position, the 15 bar pump
pumps water momentarily, followed by
a pause, then continues to pump the water
through to the ground coff ee in the Filter
Holder. The ground coff ee is moistened
by a small amount of water before full
extraction and expands resulting in greater
pressure build-up to extract all the oils and
full fl avour from the ground coff ee. The
ground coff ee expands and when greater
pressure is built up, the brewed coff ee is
extracted with its full fl avour.
NOTE:
The machine remains ready for brewing
and maintains a constant heating
temperature whilst the Power On/off
button is in the ‘On’ position. If the
temperature lowers, the heating light
will illuminate and the Thermoblock
Heating System will automatically
reheat to the correct brewing
temperature
STEP 8 – EMPTYING THE FILTER HOLDER
•
Remove the Filter Holder from the Brew
Head by turning the Filter Holder to the left
until it releases. To empty the used coff ee
grounds, turn the fi lter holder upside down
in a bin and gently tap out the coff ee (used
coff ee grounds should be thrown away
with domestic waste and not down the sink
which may block drains). Remove the Filter
by using using the indents on the side of
the Filter Holder. Rinse the Filter and Filter
Holder with water and allow to dry.
16
OPERATING YOUR ESPRESSO MACHINE ES 8010