Catler ES 8010 - Manual (Page 25)

CARE AND CLEANING
25 25
CARE AND CLEANING
CLEANING THE STEAM WAND AND
FROTHING ATTACHMENT
•
The Steam Wand and Frothing Attachment
should always be cleaned after frothing
milk.
• Remove the Frothing Attachment and rinse
in warm tap water. Ensure the two fi ne
steam holes on either end of the Frothing
Attachment are clear. Use the pin on the
Cleaning Tool to unblock these holes.
• Wipe the Steam Wand with a damp cloth,
then with the Steam Wand directed back
into the drip tray, briefl y set the Selector
Control to the ‘Steam’ position and
press the Hot Water button. This will clear
any remaining milk from inside the Steam
Wand.
• Ensure the Selector Control is in the
‘Standby’ position. Press the „on/off “
button to off , switch off at the power
outlet, unplug the power cord and allow
the machine to cool.
• If the Steam Wand remains blocked, use
the pin on the Cleaning Tool to clear the
opening.
• If the Steam Wand continues to be blocked,
the tip of the Steam Wand can be removed
by using the spanner in the middle of the
Cleaning Tool.
• Soak the tip in hot water before using
the pin on the Cleaning Tool to unblock.
Replace the tip back onto the Steam Wand
and secure with the Cleaning Tool.
Caution!
The pin on the Cleaning Tool is sharp.