Steps to assemble – ETS-Lindgren HI-4422 Field Probe (Archived) User Manual
Page 73
Advertising
S
TEPS TO
A
SSEMBLE
1.
Insert the probe stand tube into the base plate.
• For accurate measurements, make sure to completely insert the
probe stand tube into the base plate. When fully inserted, the
bottom of the tube should rest evenly on the floor or surface.
• On the bottom of the base plate are rubber feet. Make sure all feet
rest evenly on the floor or surface.
• Incorrect tube placement or an uneven base can cause inaccurate
measurements.
H-491269 Probe Stand
| 73
Archived 6/29/10
Use only the content for
HI-4422 in this manual.
Disregard content for
all other probe models;
see ETS-Lindgren
website for other
probe content.
Advertising