Kontron AT8050 - Manual (Page 123)

Software Setup
107 AT8050
www.kontron.com
5.1.7.6 Gateway Address Configuration sub-menu
5.1.7.7 VLAN ID Configuration
Feature Option Description Help text
LAN Parameter Selector 12
The parameter selector assignments are
described in IPMI Specification 2.0, table 23-
3. Selector #12: Default Gateway Address.
N/A, display only.
Channel Number 01 or 02
Each interface has a channel number that is
used when configuring the channel and for
routing messages between channels. Channels
01 and 02 on Base interface are available. The
channel number assignments are described in
IPMI Specification 2.0, table 6-1.
Enter Channel Number
for SET LAN Config
Command. Proper value
01 or 02.
Channel Status: Valid or Invalid Display Valid if IPMC support LAN Channel. N/A, display only.
IP Address Source Static or DHCP
Select whether IP Address is set static or
retreive using DHCP.
Select IP Address
Source: Static or DHCP
Current Gateway Address: xxx.xxx.xxx.xxx
Display the current Gateway configuration
stored in IPMI NVRAM for IPMI LAN.
N/A, display only.
Gateway Address xxx.xxx.xxx.xxx
This allows setting an Gateway IP Address for
LAN configuration when IP Address Source is
set to static. This option is hiden when DHCP
source is selected.
Enter Gateway IP
Address in decimal in the
form of XXX.XXX.XXX.XXX
(XXX less than 256 and
in decimal only).
Feature Option Description Help text
LAN Parameter Selector 20
The parameter selector assignments are
described in IPMI Specification 2.0, table 23-
4. Selector #20: 802.1q VLAN ID (12-bit).
N/A, display only.
Channel Number 01 or 02
Each interface has a channel number that is
used when configuring the channel and for
routing messages between channels. Channels
01 and 02 on Base interface are available. The
channel number assignments are described in
IPMI Specification 2.0, table 6-1.
Enter Channel Number
for SET LAN Config
Command. Proper value
01 or 02.
Channel Status: Valid or Invalid Display Valid if IPMC support LAN Channel. N/A, display only.
802.1q VLAN ID Value xxx
This allows setting an 802.1q VLAN ID for LAN
configuration.
Enter VLAN ID value in
decimal. VLAN ID must
be between 1 and 4094.
Current 802.1q VLAN ID
Value:
xxxx
Display the current 801.1q VLAN ID
configuration stored in IPMI NVRAM for IPMI
LAN.
N/A, display only.
Support VLAN Tagged
Packets
Enabled
Disabled Select if 802.1q VLAN tagged packets are
added.
Select if VLAN Tagged
Packets are to be added
or not.
VLAN Tagged Packets
Status:
Enabled or Disabled
Display the current status of the 801.1q VLAN
tagged packets configuration stored in IPMI
NVRAM for IPMI LAN.
N/A, display only.