4 boot menu pop-up, 3 console redirection (vt100 mode), 1 requirements – Kontron AT8050 User Manual
Page 130: 2 ansi and vt100 keystroke mapping, Boot menu pop-up, Requirements, Ansi and vt100 keystroke mapping
Software Setup
114
www.kontron.com
4 BIOS mention: "Please wait, invoking SAS Configuration Utility..."
"***LSI Corp Configuration Utility will load after initialization***"
5 Select "SCSI:LSI MPI Boot Support" in Popup menu
The menu is now available.
5.2.4
BOOT Menu POP-UP
The BOOT Menu POP-UP expands your boot options by letting you choose your boot device, which could be a
hard disk, floppy disk, CDROM, Flash Disk, SCSI or LAN. You can select your boot device in Setup, or you can
choose a different device each time you boot during POST by selecting your boot device in the Boot device
<F11> (or <F3> from a Console Redirection terminal).
5.3
Console Redirection (VT100 Mode)
The VT100 operating mode allows remote setup of the board. This configuration requires a remote terminal
that must be connected to the board through a serial communication link.
5.3.1
Requirements
The terminal should emulate a VT100 or an ANSI terminal. Terminal emulation programs such as Telix©,
HyperTherminal(Windows), minicom(Linux) or ProComm©(Windows) can also be used.
5.3.2
ANSI and VT100 Keystroke Mapping
Up
<ESC>[A
Down
<ESC>[B
Right
<ESC>[C
Left
<ESC>[D
Home
<ESC>[H
End
<ESC>[K
F1
<ESC>OP
F2
<ESC>OQ
F3
<ESC>OR
F4
<ESC>OT