Mercedes-Benz CL-Class 2007 User Manual
Page 654
651
Practical hints
Flat tire
1 Wheel wrench
̈
Take wheel wrench
1 out of the vehi-
cle tool kit tray.
̈
On wheel to be changed, lossen but do
not yet remove the wheel bolts (ap-
proximately one full turn with wheel
wrench
1).
The jack take-up brackets are located di-
rectly behind the front wheel housings and
in front of the rear wheel housings.
2 Jack take-up bracket
3 Jack
4 Crank
̈
Place jack
3 on firm ground.
̈
Position jack
3 under take-up
bracket
2 so that it is always vertical
(plumb-line) as seen from the side,
even if the vehicle is parked on an
incline.
̈
Jack up the vehicle until the wheel is a
maximum of 1.2 in (3 cm) from the
ground. Never start engine while
vehicle is raised.
Warning!
G
Position the jack only on the jack take-up
brackets designed for this purpose.
If the jack is not properly positioned, the ve-
hicle may slip off of the jack.
୴୴