Rice Lake IQ plus 2100SL Digital Bench Scale - Manual (Page 16)

18 IQ plus 2100 Installation Manual
3.2.4 Serial Menu
Figure 3-9. Serial Menu
BITS BAUD
9600
7ODD
7EVEN
8NONE
4800
2400
1200
XXXXXXX XXXXXXX VERS DEFLT DIG IN SERIAL CALIBR CONFIG FORMAT
PRNFRQ
DEMAND
AUTO1
AUTO2
STREAM
TERMIN
CR
CR/LF
ECHO
ON
OFF
SERIAL Menu
Parameter Choices Description
BAUD 9600
1200
2400
4800 Baud rate. Selects the transmission speed for the serial port.
BITS 8NONE
7EVEN
7ODD Selects number of data bits and parity of data transmitted from the serial port.
TERMIN CR/LF
CR Termination character. Selects termination character for data sent from the serial port.
ECHO OFF
ON This command enables or disables echoing of the serial commands sent to the indicator.
PRNFRQ DEMAND
AUTO1
AUTO2
STREAM Print frequency. Specifies when the indicator sends data to the serial port:
DEMAND: When a PRINT digital input is activated or the KPRINT EDP command received.
AUTO1: Output enabled by scale in motion; transmitted when scale returns to standstill.
AUTO2: Output enabled by scale at center of zero; transmitted when a positive scale weight
is at standstill.
STREAM: Continuous output. See Section 6.3 on page 26 for output format.
Weight data is sent to the serial port in displayed units except when other units are specified
using one of the XGx EDP commands (see Section 5.1.5 on page 24).
If DEMAND, AUTO1, or AUTO2, is selected for this parameter, serial output is formatted as
follows:
wwwwwww uu GROSS
where wwwwww is a 7-digit weight field (leading zeroes suppressed, including decimal point and
minus sign, if required), uu is the units designator (lb, kg, oz, or G).
If pounds/ounces (LB/OZ) is specified as the primary units, the serial output is formatted as
shown below:
xxx lb yyyy oz GROSS
where xxx is the three-digit pounds weight (including minus sign, if required) followed by lb and
a space; and yyyy is the four-digit ounce weight (including decimal point) followed by oz .
Table 3-5. Serial Menu Parameters