Rice Lake TicketPress - Installation and Operation Manual - Manual (Page 13)

Printer Configuration 9
4.1.3 Entering a Menu
Once the display shows your choice of either OPTIONS, SECURITY or INTERFACE :
1. Press and hold approximately two seconds to enter that menu. The display will change to show the
first item available in the menu.
4.1.4 Making Changes
The values for most menu items can be changed by pressing to cycle through the items available and then
pressing to change the value.
Note
Remember the value that will be saved is the value displayed when you press to advance
to the next menu item or exit the menu.
The one area where changing values works differently is for making changes to the location, time, date and ID.
To change these values see “Options Menu” on page 9.
4.1.5 Exiting Setup
1. If you are currently in the options or interface menu, press until OPTIONS or INTERFACE menu is
displayed.
2. Press until Exit Setup Menus is displayed.
Exiting Menus
No Changes
Note
Note that the bottom line displays Save Changes. If you wish to exit without saving any changes,
press to display Discard Changes.
3. Press and hold to exit setup. The printer will display one of the following messages. No Changes
will be displayed automatically if no changes were made or if Discard Changes was selected.
Exiting Menus
Save Changes
or
4.2 Options Menu
The OPTIONS menu is used to configure various operating modes, current time and date, and ticket ID values of
the TicketPress .
Options
Enter Setup and select the OPTIONS menu as describe earlier. Each menu item and possible values are described
in detail as follows. The factory default values are indicated with an asterisk (*) where applicable.