Rice Lake TicketPress - Installation and Operation Manual - Manual (Page 14)

10 TicketPress Operator’s Manual
4.2.1 Loc, Time, Date
Loc,Time,Date
No
Controls whether the location, time, date, and ticket ID number are printed, and if so,
where.
Value Action
Off *
Press to skip all the related value settings and advance to the Ticket Out Fault menu item.
Print First Time, date and ticket ID will be printed at the top of the next ticket followed by one blank line.
Press to proceed to setting ALL of the values for location, time, date, and ticket ID.
Print Last Time, date, and ticket ID will be printed on line following the weight after a <CR>.
Press to proceed to setting ALL of the values for location, time, date, and ticket ID.
Print After Unit Time, date, and ticket ID will be printed following the weight on the same line.
Press to proceed to setting ALL of the values for location, time, date, and ticket ID.
This value is only valid when “Print Mode” is set to Weight Extraction.
Note
When set to any value other than No, you must advance through the values for all of the items
below before continuing on to the remaining options menu items.
Submenus:
Location.
This item sets the format used to display and print the time and date as described for
each of those items below.
Location
US
Value Action
US *
Use to select the desired value, then press advance to Time.
Intl
Time
Value Display Action
US *
Time
12:00 AM
Each portion of the time will be highlighted and may be changed by pressing
.
Press to highlight the next value to be set, or press and hold to
advance to Date.
Intl
Time
23:00
The two formats shown are selected by setting the location to US or Intl.
Note To exit when Time/Date is turned on press twice until Options is displayed.