Rice Lake TicketPress - Installation and Operation Manual - Manual (Page 36)

32 TicketPress Operator’s Manual
8.0 Printer Commands
8.1 Communications
This section describes various methods of controlling the flow of data to and from the printer. Unlike other
sections describing printer commands, the descriptions in this section indicate whether the command is one that
is “received” by the printer, or “transmitted” by the printer.
Note that some handshaking methods are only supported by the RS-232 Serial interface and are not supported for
the IrDA, Bluetooth, or Wi-Fi interfaces.
8.2 Print Position Commands
Line Feed (Ctrl J) LF
Causes the current line to be printed, and then advances the ticket one line. If Auto CR is set to On in the
interface setup menu, a carriage return will also be performed.
Control code: LF
Hexadecimal: 0A
Vertical Tab (Ctrl K) VT
Causes a Carriage Return and Line Feed (CRLF) to be performed
Control code: VT

Hexadecimal: 0B
Form Feed (Ctrl L) FF
(Must use Ctrl L with Ctrl K)
Causes ________________
Control code: FF
Hexadecimal: 0C
Carriage Return (Ctrl M) CR
Causes the current line to be printed, and then sets the current print position to the left margin. If Auto LF is set
to On in the interface setup menu, a line feed will also be performed.
Control code: CR
Hexadecimal: 0D
Toggle Wide Print (Ctrl W)
Causes print to change to 2xWide and 2xHigh.
Control code: ETB
Hexadecimal: 17
Toggle High Print (Ctrl T)
Causes print to change to 2X High
Control code: ETB
Hexadecimal: 14
Request Time & Date (Ctrl V) SYN
Causes _____________________ ***
Control code: SYN
Hexadecimal: 16