Rice Lake TicketPress - Installation and Operation Manual - Manual (Page 30)

26 TicketPress Operator’s Manual
2. Remove the two cover screws on the back of the printer.
3. Loosen the two side screws.
Figure 6-3. Removing Printer Top Cover
4. Spread the sides away from the center of the printer, then lift the rear of the cover and rotate it off the
base of the printer. Lay the top cover to the side of the base as shown below.
Remove Screws and Blank Cover
Figure 6-4. Optional Interface Blank Cover
5. Remove the two screws and blank cover at the optional I/O mounting position.