Rice Lake TransAct 2.0 - Manual (Page 6)

5
Installation
The setup program looks for any previously installed versions of TransAct
and recommends installation to that same directory. For a first time
installation, the setup program recommends installation to the directory
c:\transact. Unless there is a particular reason, do not change the directory.
Click OK to continue and accept
the default installation directory.
The TransAct setup program
starts installing the program
files, displaying a status bar to
monitor the progress.
When prompted, insert the
remaining two installation disks. Click OK to continue installation.
The AUTOEXEC.BAT configuration file must include the command
SHARE /F:5100 /L:500 for TransAct to run. If TransAct needs to add this
command, the following message appears:
Default Installation Directory
Click Yes to add the command and continue.
The Windows 3.1 and Windows 95 Share program installs file-sharing and
locking capabilities. Windows for Workgroups uses the VSHARE command
instead of the SHARE command. If TransAct needs to add this command,
an additional message appears.
Click Yes to make the necessary changes and continue.
The following message appears when installation is 100% complete:
Click OK to continue.
Installation of TransAct for Windows 2.0
is now complete. We are certain you will find this
program a valuable asset to your truck scale operation.
Please contact your Rice Lake Weighing systems representative
if you have any questions.