Rice Lake TransAct 2.0 - Manual (Page 87)

86 Accounting
Default Minimum Charges Table
Use this table to setup default Minimum Charges by unit of measure
(Pound, Yard, and Count) and direction of transaction (Incoming or
Outgoing).
When the Minimum Charge for a category item is 0.00000, TransAct
applies the default minimum charges to the charge calculation.
Press the Tab key to move through the dialog boxes, or use the
mouse to click inside the box, then enter the value.
Minimum Charges for a Category Item
If individual category items receive a different minimum charge,
click Update Individual [Category] Codes. The Refuse Table
Minimum Charges table appears.
9.3 Minimum Charges
TransAct applies the Minimum Charge to a transaction when the calculated
measured rate is less than the value in the Minimum Charges table.
Note: If you do not use a minimum charge, do not enter anything in this table.
Open the table to verify that all category items are set to 0.0. Set items to 0.0
if necessary.
Default Minimum Charges
Select Accounting

Minimum Charges to access the Minimum
Charges table (below).