Curtis ENABLE 40 - Manual (Page 20)

14 Curtis enAble ® 40-Series Manual, Rev. B
Drive with Actuators and Lights (8-button Keypad)
This keypad’s eight buttons are the standard four (On/Off, Horn, Speed Up,
Speed Down) plus a Running Lights button, two buttons for the turn indica-
tors (left and right), and an Actuator Mode button.
The hazard lights (i.e., flashing left and right turn signals, front and rear)
are activated by pressing both turn indicator buttons simultaneously. They will
continue to flash even if the system is powered down. To turn off the hazard
lights, press either indicator button again.
Both actuator modes are accessed with the single Mode button.
Running Lights Button
Pressing the Running Lights button turns on the headlamps and any other
running lights on the chair. Pressing the button again turns them off. When
the lights are on, the running lights icon in the LCD is illuminated.
Turn Indicator Buttons
The Left and Right Turn Indicator buttons activate the corresponding turn
indicators. Pressing the turn indicator button again will turn the indicator off.
Also, note that pressing the opposite turn indicator button will cancel the first
indicator and activate the new one.
The turn indicator icons in the LCD flash in synchronicity with the
actual turn indicator lights.
Fig. 8c Keypad for the
Drive + Actuators + Lights
handcontrol.
3 — USER HANDCONTROL
M