Curtis ENABLE 40 - Manual (Page 22)

16 Curtis enAble ® 40-Series Manual, Rev. B
LCD DISPLAY
The LCD on the handcontrol briefly displays all of the system’s icons, as shown
in Figure 9, during its self-test routine on startup.
Fig. 9 LCD display on the handcontrol.
Two indicators are lit when the chair is in drive: the BDI icon (which uses
its seven bars to represent the level of charge) and the Speed Mode indicator
(which displays the active Speed Mode: 1 through 9).
Some indicators (Key Lock, Brake, Fault, Warning, Powerbase, and
Temperature Warning) are lit only when when the system detects a condition
that triggers them.
Some indicators (Charging Plug, Running Lights) are lit steadily when
the corresponding function is active. When they are flashing, they indicate the
location of a problem; the Fault or Warning or Temperature Warning will be
lit as appropriate along with the flashing icon. (See Table 1, page 46.)
The Turn Indicator icons flash in synchronicity with the actual turn in-
dicators. If there is a problem, the Warning icon will light and the Turn Signal
indicator will flash at twice its normal rate.
The Attendant Control icon is lit continuously when the chair is under
attendant control.
3 — USER HANDCONTROL
!
Running
Lights
L Turn
Indicator
Lights
Drive
Motor
Powerbase
Key
Lock
Warning
Joystick
Battery Discharge Indicator
(BDI)
Brake
Temperature
Warning
Speed
Mode
Charging
Plug
R Turn
Indicator
Lights
Fault
Legrest
Actuators
Attendant
Control
Seat
Actuator
Seatback
Actuator