Curtis ENABLE 40 - Manual (Page 38)

32 Curtis enAble ® 40-Series Manual, Rev. B
5 — PROGRAMMABLE PARAMETERS: Multi-Function Input 3 Parameters
Multi-Function Input 3 can be used to provide a swivel chair function (=1). Al-
ternatively, it can be used to provide an appropriate speed limit when a switch
is activated (=2). Multi-Function Input 3 is at Pin 7 on the 14-pin connector;
see Figure 6, page 9.
MULTI-FUNCTION INPUT 3 MENU
PARAMETER RANGE DESCRIPTION
Off / Swvl / Seat 0–2 0 = Multi-Function Input 3 ignored.
1 = Provides swivel chair function. This is used specifically for
chairs with seats that can rotate from rear drive to front drive.
With this parameter set to 1, the Profile will switch from
Profile 1 to Profile 2 when Input 3 is active (see next parameter).
In addition, the motor directions will be inverted and swapped.
The MyChair setting is ignored when in swivel mode.
2 = Sets the speed limit specified below when Input 3 is active.
Active Low On/Off When programmed On, the Inhibit and Speed Limit functions are
active when the switch is closed (pulled low to B-); when programmed
Off, these functions are active when the switch is open.
Charger inhibit On/Off Enables Input 3 to be used with an on-board charger. The charger will
pull the inhibit active during charging, which will inhibit drive, light the
charger and battery icons in the handcontrol display, and engage the
EM brake.
Halt Act 1 Dir- On/Off Actuator 1 will be halted in the negative direction.
Halt Act 1 Dir+ On/Off Actuator 1 will be halted in the positive direction.
Halt Act 2 Dir- On/Off Actuator 2 will be halted in the negative direction.
Halt Act 2 Dir+ On/Off Actuator 2 will be halted in the positive direction.
Speed Limit 0–100 % Sets the speed limit that will be in effect when Off/Swvl/Seat = 2
and Input 3 is active (see Active Low parameter).