Curtis ENABLE 40 - Manual (Page 25)

19 Curtis enAble ® 40-Series Manual, Rev. B
5 — PROGRAMMABLE PARAMETERS
5
PROGRAMMABLE PARAMETERS
The enAble ® 40 Powerchair Control System has a number of parameters that
can be programmed using a Curtis 1311 handheld programmer or Curtis 1314
PC Programming Station. The programmable parameters allow the vehicle’s
performance to be customized to fit the needs of specific applications.
For information on 1311 programmer operation, see Appendix B.
For information on how to use the parameters to optimize chair perfor-
mance, see Section 7: Tuning Guide.
The programmable parameters are grouped hierarchically into these menus:
PROGRAM MENU
— Configuration ...............................p. 20
— MyChair ........................................p. 20
— Profile 1
—Drive ........................................p. 21
—Steer ........................................p. 22
— Profile 2
(same parameters as Profile 1)
— Handcontrols ...............................p. 24
—Speed Mode ............................p. 25
—Joystick ....................................p. 26
—Sound & Display .....................p. 27
—Handcontrol Inhibit ..................p. 27
— Seat ...............................................p. 28
— Lights ............................................p. 29
— Motor Controller
—Current Limits ..........................p. 29
—Multi-Function Inputs
—Input 1 .............................p. 30
—Input 2 .............................p. 31
—Input 3 .............................p. 32
—Compensation .........................p. 33
— Motors & Brakes .........................p. 34
— Battery .........................................p. 35