Curtis ENABLE 40 - Manual (Page 43)

37 Curtis enAble ® 40-Series Manual, Rev. B
6 — MONITOR MENU
MONITOR MENU, cont’d
ITEM DISPLAY RANGE DESCRIPTION
LIGHTS • • •
Indicator Current
0–26.5 A Current through the indicator lights.
Running Light Current 0–26.5 A Current through the running lights.
MOTOR CONTROLLER • • •
M1 Bridge Temp
0 – 200 °C Temperature of power section for drive motor 1.
M2 Bridge Temp 0 – 200 °C Temperature of power section for drive motor 2.
Current Limit 0–90 A Ultimate current limit of the powerbase,
taking into account boost mode, thermal
protection, etc.
Motor Thermal Cutback 0–100 % Amount the current is being reduced due to
the motor thermal protection algorithm.
MFI Speed Limit 0–100 % Lowest speed limit in effect for MFI 1–3.
MFI1 Active On/Off Status of Multi-Function Input 1.
MFI2 Active On/Off Status of Multi-Function Input 2.
MFI3 Active On/Off Status of Multi-Function Input 3.
MOTORS & BRAKES • • •
Motor Trim
-127 – +127 Status of the Auto-Trim function.
M1 Current -90.0 – +90.0 A Current in drive motor 1.
M2 Current -90.0 – +90.0 A Current in drive motor 2.
M1 Voltage -27.5 – +27.5 V Voltage at drive motor 1.
M2 Voltage -27.5 – +27.5 V Voltage at drive motor 2.
M1 PWM -100 – +100 % PWM applied to drive motor 1.
M2 PWM -100 – +100 % PWM applied to drive motor 1.
Brake On/Off Status of electromagnetic brake.
System Resistance 0–477 Estimated motor resistance in real time.
This value will fall between the programmed
System Resistance and Hot System
Resistance values.
Resistance Test 0–477 Resistance of the system as measured by
the powerbase at the M1 and M2 terminals.
This variable only displays an accurate
resistance reading when the Motor Test
Mode parameter (see page 35) is On.
BATTERY • • •
Battery Voltage
0–38.5 V Voltage of the main battery.
BDI % 0–100 % Battery state-of-charge as estimated by the
powerbase.